Showing raw Markdown: the renderer could not load.
Computers count in ones and zeros, and networking is full of them: IP addresses, subnet masks and MAC addresses are just binary numbers written in a friendlier way. This module teaches you to read and convert binary and hexadecimal numbers step by step, so later modules on IP addressing and subnetting feel natural. ## Learning objectives By the end of this module you will be able to: 1. Explain what a bit and a byte are and why computers use binary. 2. Convert numbers between decimal and binary (0 to 255). 3. Convert numbers between binary and hexadecimal, and recognize hexadecimal in a MAC address. 4. Read an IPv4 address as four 8-bit numbers. ## Prerequisites - [02 — Your Home Network](../02-home-network/README.md). - For the activities: paper and pencil; optionally Python 3 to check your answers. Cost: free. ## Contents | Type | Duration | |---|---| | [Theory](lesson.md) | 30 min | | [Activities: converting numbers by hand](lab.md) | 30 min | | [Assessment (8 questions)](quiz.md) | 10 min | ## Further reading - [RFC 791](https://www.rfc-editor.org/rfc/rfc791) — Internet Protocol (where the 32-bit IPv4 address is defined)